The SPOT COAT
50 TR and SPOT COAT TR 50 WM self-adhesive backing foil
is 0,50 mm thick, transparent, crystal-clear and designed for use in indirect
coating on all offset presses via water damping pans or inking units.
The SPOT COAT TR 800 is transparent, thickness is 1,00 mm
for the application in offset presses with coating unit.
SPOT COAT
TR 800
With a hardness of 85° Shore. The operational area is for simple spots
in packaging and simply printings for partial varnishing. This foil is
for water base and UV-varnish, the special surface is suitable for both
sorts. It is maybe impossible that the ink built up because the surface
refuses the ink. The thickness is 0,8 mm within the best relief in use
of coating units. The foil can be stuck on an aluminium plate or also
on polyester foils, that's opinion of the user. SPOT COAT TR
800 is transparent, so it's possible to cut the sign of the offset
plate by seeing through the foil. In use of polyester it is possible to
cut on a light table with the use of the film montage, it's easy to cut
the spots. We deliver the SPOT COAT TR 800 in rolls of 10
m and in a largeness of 1300 mm. This foil is a solution for an easy and
low cost coating plate for partial varnishing
SPOT COAT 50 TR
with a hardness of approximately 115° Shore, but easily cut by hand, the
thickness is 0,50 mm. Designed specifically for UV coating, but also suitable
for acrylic and printing varnishes. We deliver the SPOT COAT 50
TR in rolls of 10 m and in a largeness of 1300 mm.
SPOT COAT TR 50
WM
with a hardness of 85° Shore, the thickness is 0,50 mm. Excellent cutting
properties by hand or on a fleet bed plotter. No burs on the cutting edges
which may cause cuts and scores on the application roller or in the blanket.
It is designed for use with acrylic varnishes. We deliver the SPOT
COAT TR 50 WM in rolls of 10 m and in a largeness of 1150 mm.
Instructions:
The plate making method is the same for both foils, the foils are not
copy able. The SPOT COAT foil is to be glued to a clean and grease-free
offset aluminium plate. For cutting it is necessary to prepare a printing
plate ready for use, attach the foil and cut out the unprinted areas.
The design is visible through the transparent foil, resulting in a clean
cut true to register. The SPOT COAT TR 50 WM and SPOT COAT
TR 800 is also designed for cutting on the fleet bed plotter.
|